Cisco Nexus 3548

48
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
autonomous-system
autonomous-system
To configure the autonomous system (AS) number for an Enhanced Interior Gateway Routing Protocol
(EIGRP) address family, use the autonomous-system command. To revert to default, use the no form of
this command.
autonomous-system as-number
no autonomous-system [as-number]
Syntax Description
Command Default None
Command Modes Address family configuration mode
Command History
Usage Guidelines Use the autonomous-system command to set a common AS number for all EIGRP instances in an
address family.
This command requires the LAN Base Services license.
Examples This example shows how to set an AS number for EIGRP for IPv4 unicast:
switch# configure terminal
switch(config)# router eigrp 201
switch(config-router)# address-family ipv4 unicast
switch(config-router-af)# autonomous-system 64496
switch(config-router-af)#
Related Commands
as-number Autonomous system number. The range is from 1 to 65535.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
address-family
(EIGRP)
Enters the address family configuration mode for EIGRP.