Cisco Nexus 3548

320
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
router rip
router rip
To configure the Routing Information Protocol (RIP) routing process, use the router rip command. To
turn off the RIP routing process, use the no form of this command.
router rip instance-tag
no router rip
Syntax Description
Command Default No RIP routing process is defined.
Command Modes Global configuration mode
Command History
Examples This example shows how to begin the RIP routing process:
switch# configure terminal
switch(config)# router rip Enterprise
switch(config-router)#
Related Commands
instance-tag Name for this RIP instance.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
ip router rip Specifies a RIP instance for an interface.