Cisco Nexus 3548

161
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
ip delay eigrp
ip delay eigrp
To configure the throughput delay for the Enhanced Interior Gateway Routing Protocol (EIGRP) on an
interface, use the ip delay eigrp command. To restore the default, use the no form of this command.
ip delay eigrp instance-tag seconds
no ip delay eigrp instance-tag
Syntax Description
Command Default 100 (10-microsecond units)
Command Modes Interface configuration mode
Command History
Usage Guidelines You configure the throughput delay on an interface in 10-microsecond units. For example, if you set the
ip delay eigrp command to 100, the throughput delay is 1000 microseconds.
This command requires the LAN Base Services license.
Examples This example shows how to set the delay to 400 microseconds for the interface:
switch# configure terminal
switch(config)# router eigrp 1
switch(config-router)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# ip delay eigrp 1 40
switch(config-if)#
Related Commands
instance-tag Name of the EIGRP instance. The instance-tag can be any
case-sensitive, alphanumeric string up to 20 characters.
seconds Throughput delay, in tens of microseconds. The range is from 1 to
16777215.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
ip hello-interval eigrp Configures the hello interval on an interface for the EIGRP routing
process that is designated by an autonomous system number.
show ip eigrp Displays EIGRP information.