Cisco Nexus 3548

135
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
hardware ip glean throttle syslog
hardware ip glean throttle syslog
To generate a syslog if the number of packets that get dropped for a specific flow exceeds the configured
packet count, use the hardware ip glean throttle syslog command. To return to the default setting, use
the no form of this command.
hardware ip glean throttle syslog pkt-count
no hardware ip glean throttle syslog
Syntax Description
Command Default 10000
packets
Command Modes Global configuration mode
Command History
Usage Guidelines Before you use this command, make sure that you enable the IP glean throttle feature by using the
hardware ip glean throttle command.
After the timeout period is exceeded, the drop adjacencies are removed from the FIB.
Note The Adjmgr generates a syslog for the configured packet count that will not be accurate to the dropped
glean packets that are forwarded to the FIB. The drop statistics collected from the FIB in the software
(Adjmgr) occurs every 2 minutes. The Adjmgr generates a syslog only after it receives the statistics from
the FIB every 2 minutes only for the adjacencies where the drop count exceeds the configured packet
count.
This command does not require a license.
Examples This example shows how to generate a syslog if the number of packets that get dropped for a specific
flow exceed the configured packet count:
switch# configure terminal
switch(config)# hardware ip glean throttle syslog 1030
switch(config)#
pkt-count Packet count. The range is from 0 to 65535.
Release Modification
5.0(3)A1(1) This command was introduced.