Cisco Nexus 3548

271
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
next-hop-self
next-hop-self
To set the IP address of the router as the next hop address, use the next-hop-self command. To revert to
the default configuration, use the no form of this command.
next-hop-self
no next-hop-self
Syntax Description This command ahs no arguments or keywords.
Command Default None
Command Modes BGP neighbor address-family configuration mode
Command History
Usage Guidelines This command requires a LAN Enterprise Services license.
Examples This example shows how to configure the IP address of a router as the next-hop address:
switch# configure terminal
switch(config)# router bgp 102
switch(config-router)# neighbor 192.168.1.3 remote-as 64497
switch(config-router-neighbor)# address-family ipv4 unicast
switch(config-router-neighbor-af)# next-hop-self
switch(config-router-neighbor-af)#
Related Commands
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
feature bgp Enables BGP.
address-family (BGP
neighbor)
Enters the BGP neighbor address-family configuration mode.
show ip bgp Displays BGP configuration information.