Cisco Nexus 3548

54
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
capability additional-paths send
capability additional-paths send
To configure the send additional paths capability for the specified neighbor, use the capability
additional-paths send command in neighbor address family configuration mode or peer policy template
configuration mode. To disable the capability of sending additional paths, use the no form of the
command.
capability additional-paths send [disable]
no capability additional-paths send [disable]
Syntax Description
Command Default Capability of sending additional paths is disabled.
Command Modes Neighbor address family configuration (config-router-af)
VRF Neighbor address family configuration
Neighbor VPN address family configuration
Neighbor IPv6 labeled-unicast address-family configuration
Peer policy template configuration (config-router-ptmp)
Command History
Usage Guidelines Use the capability additional-paths send command to selectively enable or disable the additional paths
send capability negotiation for a particular neighbor. The ability to send and receive additional paths is
negotiated between two BGP neighbors during session establishment.
To advertise additional-paths, you also need to:
• Configure the additional-path send command in global address-family configuration mode.
• Advertise the paths (other than best-path) by using the set path-selection command.
Use the capability additional-paths send disable command to override template or address family
configurations that enable the sending of additional paths.
Use the show ip bgp neighbors command to display whether neighbors are capable of sending or
receiving additional paths.
Any changes to this command take effect only after the next session is established and do not cause any
currently established sessions to be torn down. You must restart any currently established BGP sessions
for the new configuration to take effect. Use the clear bgp command to restart sessions.
disable (Optional) Overrides any address family configuration that enables sending
additional paths.
Release Modification
6.0(2)A1(1) This command was introduced.