Cisco Nexus 3548

235
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
match ip multicast
match ip multicast
To configure the IPv4 multicast features for the route-map matching, use the match ip multicast
command. To remove the match, use the no form of this command.
match ip multicast {group address/length | source address/length | rp address/length [rp-type
asm]}
no match ip multicast
Syntax Description
Command Default None
Command Modes Route-map configuration mode
Command History
Usage Guidelines The match ip multicast command is the only match command that is evaluated in the route map. You
can specify the group prefix, group range, and source prefix to filter messages with the match ip
multicast command.
Use the route-map command to enter route-map configuration mode. Once you enter the route-map
command, the prompt changes to the following:
switch(config-route-map)#
Once you enter route-map configuration mode, you can enter the match ip multicast command.
group address/length Specifies the group address and the length of the network mask in bits in
this format: A.B.C.D/length. The network number can be any valid IP
address or prefix. The bit mask can be a number from 0 to 32.
You can configure group, source, and rp options.
source address/length Specifies the source address and the length of the network mask in bits in
this format: A.B.C.D/length. The network number can be any valid IP
address or prefix. The bit mask can be a number from 0 to 32.
You can configure group, source, and rp options.
rp address/length Specifies the IPv4 rendezvous prefix (RP) and the length of the IPv4 prefix
mask in bits in this format: A.B.C.D/length. The network number can be any
valid IPv4 address or prefix. The bit mask can be a number from 0 to 32.
You can configure group, source, and rp options.
rp-type (Optional) Specifies the multicast rendezvous point type.
asm (Optional) Specifies the any-source multicast (ASM) rendezvous point
type.
Release Modification
5.0(3)A1(1) This command was introduced.