Cisco Nexus 3548

234
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
match ip address
When you are passing routes through a route map, a route map can have several sections that contain
specific match clauses. Any route that does not match at least one match clause that relates to a
route-map command is ignored; that is, the route is not advertised for outbound route maps and is not
accepted for inbound route maps. If you want to modify some particular data, you must configure a
second route map section with an explicit match specified.
This command requires the LAN Base Services license.
Examples This example shows how to match routes that have addresses specified by an access list test:
switch# configure terminal
switch(config)# interface ethernet 2/10
switch(config-if)# no switchport
switch(config-if)# exit
switch(config)# route-map chicago
switch(config-route-map)# match ip address test
switch(config-route-map)#
Related Commands Command Description
match as-path Matches a BGP autonomous system path access list.
match community Matches a BGP community.
match interface Distributes any routes that have their next hop out one of the
interfaces specified.
match ip next-hop Redistributes any routes that have a next-hop router address
passed by one of the access lists specified.
match ip route-source Redistributes routes that have been advertised by routers and
access servers at the address specified by the access lists.
match metric Redistributes routes with the metric specified.
match route-type Redistributes routes of the specified type.
match tag Redistributes routes in the routing table that match the specified
tags.
route-map Defines the conditions for redistributing routes from one
routing protocol into another.
set as-path Modifies an autonomous system path for BGP routes.
set automatic-tag Automatically computes the tag value.
set community Sets the BGP communities attribute.
set level Indicates where to import routes.
set local-preference Specifies a preference value for the autonomous system path.
set metric (BGP, OSPF, RIP) Sets the metric value for a routing protocol.
set metric-type Sets the metric type for the destination routing protocol.
set next-hop Specifies the address of the next hop.
set tag Sets a tag value of the destination routing protocol.
set weight Specifies the BGP weight for the routing table.