Cisco Nexus 3548

223
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
match as-number
match as-number
To match to a Border Gateway Protocol (BGP ) autonomous system (AS) number, use the match
as-number command. To remove an AS number list entry, use the no form of this command.
match as-number {number [,number...] | as-path-access-list name [...name]}
no match as-number {number [,number...] | as-path-access-list name [...name]}
Syntax Description
Command Default None
Command Modes Route-map configuration mode
Command History
Usage Guidelines Use this command to provide a list of AS numbers or an AS-path access list using a regular expression.
BGP uses this match criteria to determine the BGP peers that will be used to create a BGP session.
Use the route map to specify a range of AS numbers whose peers can establish a session with the local
BGP through prefix peering. Cisco NX-OS ignores any other match commands if the match as-number
command is present in the route map.
This command requires the LAN Enterprise Services license.
Examples This example shows how to configure a list of AS numbers:
switch# configure terminal
switch(config)# route-map IGP2BGP
switch(config-route-map)# match as-number 64496, 64498-64510
switch(config-route-map)#
number AS number. The range is from 1 to 65535.
...number (Optional) AS number. The range is from 1 to 65535.
as-path-access-list
name
Specifies an AS-path access list to match AS numbers against. The name can
be any alphanumeric string up to 63 characters.
...name (Optional) AS-path access list. The name can be any alphanumeric string up
to 63 characters.
Release Modification
5.0(3)A1(1) This command was introduced.