Cisco Nexus 3548

370
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
threshold percentage
threshold percentage
To set a threshold percentage for a tracked object in a list of objects, use the threshold percentage
command. To disable the threshold percentage, use the no form of this command.
threshold percentage {up number [down number] | down number [up number]}
no threshold percentage
Syntax Description
Command Default None
Command Modes Tracking configuration mode
Command History
Usage Guidelines When you configure a tracked list using the track object-number list command, there are two keywords
available: boolean and threshold. If you specify the threshold keyword, you can specify either the
percentage or weight keywords. If you specify the percentage keyword, the weight keyword is
unavailable. If you specify the weight keyword, the percentage keyword is unavailable.
You should configure the up percentage first. The valid range is from 1 to 100. The down percentage
depends on what you have configured for up. For example, if you configure 50 percent for up, you see
a range from 0 to 49 percent for down.
This command does not require a license.
Examples This example shows how to configure the tracked list 11 to measure the threshold using an up percentage
of 50 and a down percentage of 32:
switch# configure terminal
switch(config)# track 11 list threshold percentage
switch(config-track)# object 1
switch(config-track)# object 2
switch(config-track)# threshold percentage up 50 down 32
switch(config-track)#
up Specifies the up threshold.
down (Optional) Specifies the down threshold.
number Threshold value. The range is from 0 to 100.
Release Modification
5.0(3)A1(1) This command was introduced.