Cisco Nexus 3548

130
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
feature vrrp
feature vrrp
To enable the Virtual Router Redundancy Protocol (VRRP), use the feature vrrp command. To disable
VRRP, use the no form of this command.
feature vrrp
no feature vrrp
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
Command History
Usage Guidelines You must enable the VRRP feature before you can configure VRRP.
This command does not require a license but if you want to enable Layer 3 interfaces, you must install
the LAN Base Services license.
Examples This example shows how to enable the VRRP feature:
switch# configure terminal
switch(config)# feature vrrp
switch(config)#
This example shows how to disable the VRRP feature:
switch# configure terminal
switch(config)# no feature vrrp
switch(config)#
Related Commands
Release Modified
5.0(3)A1(1) This command was introduced.
Command Description
clear vrrp Clears all the software counters for the specified virtual router.
show feature Displays the status of features on a switch.
show vrrp Displays VRRP configuration information.
vrrp Configures a VRRP group on an interface.