Cisco Nexus 3548

293
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
redistribute (BGP)
redistribute (BGP)
To inject routes from one routing domain into the Border Gateway Protocol (BGP), use the redistribute
command. To remove the redistribute command from the configuration file and restore the system to
its default condition in which the software does not redistribute routes, use the no form of this command.
redistribute {direct | eigrp instance-tag | ospf instance-tag | rip instance-tag | static} [route-map
map-name]
no redistribute {direct | eigrp instance-tag | ospf instance-tag | rip instance-tag | static}
[route-map map-name]
Syntax Description
Command Default Disabled
Command Modes Address family configuration mode
Router configuration mode
Router VRF configuration mode
Command History
Usage Guidelines You should always use a route map to filter these routes to ensure that BGP redistributes only the routes
that you intend to redistribute.
You must configure a default metric to redistribute routes from another protocol into BGP. You can
configure the default metric with the default-metric command or with the route map configured with
the redistribute command.
This command requires the LAN Enterprise Services license.
Examples This example shows how to redistribute BGP routes into an EIGRP autonomous system:
direct Distributes routes that are directly connected on an interface.
eigrp instance-tag Specifies the name of an EIGRP instance. The instance-tag can be
any case-sensitive, alphanumeric string up to 20 characters.
ospf instance-tag Distributes routes from the OSPF protocol. This protocol is
supported in the IPv4 address family. The instance-tag can be any
case-sensitive, alphanumeric string up to 20 characters.
rip instance-tag Distributes routes from the RIP protocol. The instance-tag can be any
case-sensitive, alphanumeric string up to 20 characters.
static Redistributes IP static routes.
route-map map-name (Optional) Specifies the identifier of a configured route map. Use a
route map to filter which routes are redistributed into EIGRP.
Release Modification
5.0(3)A1(1) This command was introduced.