Cisco Nexus 3548

77
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
clear ip eigrp neighbors
clear ip eigrp neighbors
To remove and reestablish the Enhanced Interior Gateway Routing Protocol (EIGRP) neighbor entries
from the appropriate table, use the clear ip eigrp neighbors command.
clear ip eigrp neighbors [* | ip-address | ethernet slot/port | loopback if_number | port-channel
number] [soft] [vrf {vrf-name | all | default | management}]
Syntax Description
Command Default When no autonomous system number, interface, or VRF instance is specified, all EIGRP neighbor
entries are cleared from the table.
Command Modes Any command mode
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to clear all EIGRP entries for neighbors on Ethernet interface 2/1:
switch# clear ip eigrp neighbors ethernet 2/1 vrf *
* (Optional) Clears all neighbors.
ip-address (Optional) Address of the neighbor.
ethernet slot/port (Optional) Clears the Ethernet interface from the neighbor table. The
slot number is from 1 to 255, and the port number is from 1 to 128.
loopback if_number (Optional) Clears the loopback interface from the neighbor table. The
loopback interface number is from 0 to 1023.
port-channel number (Optional) Clears the EtherChannel interface and EtherChannel
number from the neighbor table. The range is from 1 to 4096.
soft (Optional) Specifies soft reset for the neighbors.
vrf vrf-name (Optional) Specifies a virtual routing and forwarding (VRF) instance.
The VRF name is an alphanumeric string of up to 32 characters.
all (Optional) Clears the EIGRP neighbor information from all VRF
instances.
default (Optional) Clears the EIGRP neighbor information from the default
VRF.
management (Optional) Clears the EIGRP neighbor information from the
management VRF.
Release Modification
5.0(3)A1(1) This command was introduced.