Cisco Nexus 3548

15
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
address-family (RIP)
address-family (RIP)
To configure an address family for the Routing Information Protocol (RIP), use the address-family
command in router configuration mode.
address-family ipv4 unicast
Syntax Description
Command Default This command has no default settings.
Command Modes Router configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to set the IPv4 unicast address family for a RIP instance:
switch# configure terminal
switch(config)# router rip Enterprise
switch(config-router)# address-family ipv4 unicast
switch(config-router)#
Related Commands
ipv4 Specifies the IPv4 address family.
unicast Specifies unicast address support.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
default-information Controls the distribution of a default route.
default-metric Configures the default metric for routes redistributed into RIP.
distance Configures the administrative distance.
maximum-paths Configures the maximum number of equal-cost paths.
redistribute Configures route redistribution for RIP.
show ip rip Displays a summary of RIP information for all RIP instances.
timers Configures the RIP timers.