Cisco Nexus 3548

165
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
ip eigrp shutdown
ip eigrp shutdown
To shut down the Enhanced Interior Gateway Routing Protocol (EIGRP) on an interface, use the ip eigrp
shutdown command. To restore the default, use the no form of this command.
ip eigrp instance-tag shutdown
no ip eigrp instance-tag shutdown
Syntax Description
Command Default None
Command Modes Interface configuration mode
Command History
Usage Guidelines When you shut down the interface for EIGRP and prevent EIGRP adjacency for the interface for
maintenance purposes, the network address for the interface does not show up in the EIGRP topology
table. Use the ip passive-interface eigrp command to prevent EIGRP adjacency but keep the network
address in the topology table.
This command requires the LAN Base Services license.
Examples This example shows how to disable EIGRP on an interface:
switch# configure terminal
switch(config)# router eigrp 201
switch(config-router)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# ip eigrp 201 shutdown
switch(config-if)#
Related Commands
instance-tag Name of the EIGRP instance. The instance-tag can be any
case-sensitive, alphanumeric string up to 20 characters.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
ip passive-interface eigrp Configures an instance of EIGRP.
router eigrp Configures an instance of EIGRP.