Cisco Nexus 3548

256
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
maximum-paths (RIP)
maximum-paths (RIP)
To configure the maximum number of equal cost parallel routes that the Routing Information Protocol
(RIP) can install into the routing table, use the maximum-paths command. To remove the
maximum-paths command and restore the system to its default condition, use the no form of this
command.
maximum-paths maximum
no maximum-paths
Syntax Description
Command Default 8 paths
Command Modes Router address-family configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to allow a maximum of 16 equal cost paths to a destination:
switch# configure terminal
switch(config)# router rip Enterprise
switch(config-router)# address-family ipv4 unicast
switch(config-router-af)# maximum-paths 16
switch(config-router-af)#
Related Commands
maximum Maximum number of parallel routes that RIP can install in a routing table.
The range is from 1 to 32.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
address-family Enters address-family configuration mode.
copy running-config
startup-config
Saves the configuration to the startup configuration file.
show ip rip Displays a summary of RIP information for all RIP instances.