Cisco Nexus 3548

139
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
hsrp
hsrp
To enter Hot Standby Router Protocol (HSRP) configuration mode and create an HSRP group, use the
hsrp command. To disable HSRP, use the no form of this command.
hsrp group-number ipv4
no hsrp group-number ipv4
Syntax Description
Command Default Disabled
Command Modes Interface configuration mode
Command History
Usage Guidelines You must globally enable HSRP before you can configure any HSRP options or create an HSRP group.
This command does not require a license.
Examples This example shows how to create and activate an HSRP group:
switch# configure terminal
switch(config)# interface ethernet 0
switch(config-if)# no switchport
switch(config-if)# ip address 192.168.0.5 255.255.255.0
switch(config-if)# hsrp 1
switch(config-if-hsrp)#
Related Commands
group-number Number of HSRP groups that can be configured on a Gigabit Ethernet port,
including the main interfaces and subinterfaces. The range is from 1 to 255.
The default value is 0.
ipv4 (Optional) Sets the HSRP group for IPv4.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
feature hsrp Enables the HSRP configuration.
show hsrp Displays HSRP information.
ip address Creates a virtual IP address for the HSRP group. The IP address must be in
the same subnet as the interface IP address.