Cisco Nexus 3548

201
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
ip rip offset-list
ip rip offset-list
To add an offset to incoming and outgoing metrics to routes learned via Routing Information Protocol
(RIP), use the ip rip offset-list command. To remove an offset list, use the no form of this command.
ip rip offset-list value
no ip rip offset-list
Syntax Description
Command Default value: 1
Command Modes Router address-family configuration mode
Command History
Usage Guidelines This command does not require a license but if you want to enable Layer 3 interfaces, you must install
the LAN Base Services license.
Examples This example shows how to configure an offset of 10 for all incoming RIP routes on Ethernet interface
2/1:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# ip rip offset-list 10
switch(config-if)#
Related Commands
value Value to add to the incoming route metric for an interface. The range is from
1 to 15. The default is 1.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
ip rip metric-offset Adds an offset value to incoming RIP route metrics.