Cisco Nexus 3548

69
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
clear ip arp
clear ip arp
To clear the Address Resolution Protocol (ARP) information, use the clear ip arp command.
clear ip arp [ip-addr | ethernet slot/port[.sub_if] | loopback if_number | port-channel
number[.sub_if_number]] [force-delete | statistics] [vrf vrf-name | all | default | management]
Syntax Description
Command Default None
Command Modes Any command mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to clear the ARP table:
switch# clear ip arp
ip-addr (Optional) IPv4 source address. The format is x.x.x.x.
ethernet
slot/port
(Optional) Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
sub_if (Optional) Specifies the Ethernet subinterface port number. The range is from 1 to
48.
loopback
if_number
(Optional) Specifies the loopback interface. The loopback interface number is from
0 to 1023.
port-channel
number
(Optional) Specifies the EtherChannel interface and EtherChannel number. The
range is from 1 to 4096.
sub_if-number (Optional) Subinterface number. The range is from 1 to 4093.
force-delete (Optional) Clears the entries from the ARP table without a refresh.
statistics (Optional) Clears ARP statistics.
vrf vrf-name (Optional) Specifies the virtual routing and forwarding (VRF) context name. The
name can be any case-sensitive, alphanumeric string up to 32 characters.
all (Optional) Clears the ARP information from all VRF entries.
default (Optional) Clears the ARP information from the default VRF.
management (Optional) Clears the ARP information from the management VRF.
Release Modification
5.0(3)A1(1) This command was introduced.