Cisco Nexus 3548

204
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
ip rip route-filter
ip rip route-filter
To filter the Routing Information Protocol (RIP) routes coming in or out of an interface, use the ip rip
route-filter command. To remove filtering from an interface, use the no form of this command.
ip rip route-filter {prefix-list list-name | route-map map-name} {in | out}
no ip rip route-filter {prefix-list list-name | route-map map-name} {in | out}
Syntax Description
Command Default Route filtering is disabled.
Command Modes Interface configuration mode
Command History
Usage Guidelines This command does not require a license but if you want to enable Layer 3 interfaces, you must install
the LAN Base Services license.
Examples This example shows how to use a route map to filter routes for a RIP interface:
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# no switchport
switch(config-if)# ip rip route-filter route-map InRipFilter in
switch(config-if)#
Related Commands
prefix-list list-name Associates a prefix list to filter RIP packets.
route-map map-name Associates a route map to set the redistribution policy for RIP.
in Filters incoming routes.
out Filters outgoing routes.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
route-map Creates a route map.
prefix-list Creates a prefix list.