Cisco Nexus 3548

358
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
shutdown (VRRP)
shutdown (VRRP)
To disable a Virtual Router Redundancy Protocol (VRRP) configuration, use the shutdown command.
To enable a VRRP configuration, use the no form of this command.
shutdown
no shutdown
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes VRRP configuration mode
Command History
Usage Guidelines Shut down the virtual router before configuring the virtual router parameters; you can only configure the
virtual router after it is in the administrative shut down state. Enter the no shutdown command to update
the virtual router state after completing configuration.
This command requires the LAN Base Services license.
Examples This example shows how to shut down a VRRP group:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# vrrp 45
switch(config-if-vrrp)# shutdown
switch(config-if-vrrp)# address 6.6.6.45
switch(config-if-vrrp)# no shutdown
switch(config-if-vrrp)#
Related Commands
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
feature vrrp Enables VRRP.
show vrrp Displays VRRP configuration information.
clear vrrp Clears all the software counters for the specified virtual router.