Cisco Nexus 3548 User Manual

226
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
match as-path
match ip next-hop Redistributes any routes that have a next-hop router address passed by one
of the access lists specified.
match route-type Redistributes routes of the specified type.
match tag Redistributes routes in the routing table that match the specified tags.
route-map Defines the conditions for redistributing routes from one routing protocol
into another.
set as-path Modifies an autonomous system path for BGP routes.
set comm-list Automatically computes the tag value in a route map configuration.
set community Sets BGP community list (for deletion).
set level Indicates where to import routes.
set local-preference Specifies a preference value for the autonomous system path.
set metric (BGP,
OSPF, RIP)
Sets the metric value for a routing protocol.
set metric-type Sets the metric type for the destination routing protocol.
set origin (BGP) Sets the BGP origin code.
set tag Sets the value of the destination routing protocol.
set weight Specifies the BGP weight for the routing table.
Command Description

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back