238
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
match ip next-hop prefix-list
Examples This example shows how to distributes routes that have a next-hop router address passed by the prefix
list test:
switch# configure terminal
switch(config)# route-map blue
switch(config-route-map)# match ip next-hop prefix-list test
switch(config-route-map)#
Related Commands Command Description
match as-path Matches a BGP autonomous system path access list.
match community Matches a BGP community.
match ip address Distributes any routes that have a destination network number
address that is permitted by a standard or expanded access list.
match ip route-source Redistributes routes that have been advertised by routers and access
servers at the address specified by the access lists.
match route-type Redistributes routes of the specified type.
match tag Redistributes routes in the routing table that match the specified
tags.
route-map Defines the conditions for redistributing routes from one routing
protocol into another.
set as-path Modifies an autonomous system path for BGP routes.
set automatic-tag Automatically computes the tag value.
set community Sets the BGP communities attribute.
set level Indicates where to import routes.
set local-preference Specifies a preference value for the autonomous system path.
set metric (BGP, OSPF, RIP) Sets the metric value for a routing protocol.
set metric-type Sets the metric type for the destination routing protocol.
set next-hop Specifies the address of the next hop.
set tag Sets a tag value of the destination routing protocol.
set weight Specifies the BGP weight for the routing table.
To Next Page
Loading...
Need help?
General
