Cisco WS-C2950-24 User Manual

7-3
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Chapter 7 Configuring the Switch Ports
Changing the Port Speed and Duplex Mode
Setting Speed and Duplex Parameters
Beginning in privileged EXEC mode, follow these steps to set the speed and
duplex parameters on a port:
Configuring Flow Control on Gigabit Ethernet Ports
Beginning in privileged EXEC mode, follow these steps to configure flow control
on a Gigabit Ethernet port.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface Enter interface configuration mode, and enter the port to be
configured.
Step 3
speed {10 | 100 | auto} Enter the speed parameter for the port.
You cannot enter the speed on Gigabit Ethernet or ATM
ports.
Step 4
duplex {full | half | auto} Enter the duplex parameter for the port.
Step 5
end Return to privileged EXEC mode.
Step 6
show running-config Verify your entries.
Step 7
copy running-config
startup-config
(Optional) Save your entry in the configuration file. This
retains the configuration when the switch restarts.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface Enter interface configuration mode, and enter the port to be
configured.
Step 3
flowcontrol [asymmetric |
symmetric]
Configure flow control for the port.
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entries.
Step 6
copy running-config
startup-config
(Optional) Save your entry in the configuration file. This
retains the configuration when the switch restarts.

Cisco WS-C2950-24 Specifications

General

Brand	Cisco
Model	WS-C2950-24
Category	Switch
Language	English