Appendix A System Error Messages
Error Message and Recovery Procedures
A-8
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Link Message
This section contains the Link error message.
LINK-4-ERROR [chars] is experiencing errors.
Explanation
This messages means that excessive errors have occurred on this
interface: [char] is the interface.
Action Check for duplex mismatches between both ends of the link.
Note The previous error is a LINK-4-ERROR message, which is logged at the
Warning level. LINK-3-ERROR messages are more severe and are logged at
the Error level.
LRE Link Messages
This section contains the LRE Link error messages.
LRE_LINK-3-UPDOWN: Interface changed state to up or down
Explanation This message means that the link between the LRE port and the
CPE device has been lost and that no Ethernet traffic is being transferred. This
could be the result of reconfiguring the port, reconfiguring a profile in use by
this port, a physical disconnection or reconnection of the LRE connector on
the switch, or by someone disconnecting the CPE LRE cable or cycling its
power. It might also be caused by any substantial interruption of the signal or
cabling between the LRE port and the CPE.
Action If someone is reconfiguring the port or the profile in use, ignore this
message. However, if the LRE link does not go back up within a minute or so,
it could mean a physical disconnection at the switch or CPE or a loss of power
to the CPE.
LRE_LINK-3-PROFILE_FAILURE: Interface, profile failure
Explanation
When the switch reloads or when the LRE link is lost, the LRE
port first attempts to briefly establish link with the CPE in a common, reduced
rate mode. This is so that the switch can exchange configuration information
To Next Page
Loading...
