Cisco WS-C2950-24 - Disabling a Network Port

Chapter 7 Configuring the Switch Ports
Configuring Flooding Controls
7-8
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Beginning in privileged EXEC mode, follow these steps to define a network port:
Disabling a Network Port
Beginning in privileged EXEC mode, follow these steps to disable a network port:
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface Enter interface configuration mode, and enter the port to be
configured.
Step 3
port network Define the port as the network port.
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entry.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface Enter interface configuration mode, and enter the port to be
configured.
Step 3
no port network Disable the port as the network port.
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entry.