Cisco WS-C2950-24 - Network Port; Storm Control

4-13
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Chapter 4 General Switch Administration
Default Settings
Flooding Control
Storm control Disabled “Configuring Flooding Controls”
section on page 7-4.
Cluster Manager
Port > Flooding Control
Flooding unknown
unicast and multicast
packets
Enabled “Blocking Flooded Traffic on a Port”
section on page 7-6.
Cluster Manager
Port > Flooding Control
Cisco Group
Management Protocol
(CGMP)
Enabled “Controlling IP Multicast Packets
through CGMP” section on
page 6-46.
Cluster Manager
Device > Cisco Group
Management Protocol
(CGMP)
Multicast VLAN
Registration (MVR)
Disabled “Configuring MVR” section on
page 6-49.
–
Network Port Disabled “Enabling a Network Port” section on
page 7-7.
–
Network Redundancy
Hot Standby Router
Protocol
Disabled “Designating and Enabling Standby
Command Switches” section on
page 5-17.
–
Spanning Tree
Protocol
Enabled “Configuring STP” section on
page 6-24.
Cluster Manager
Device > Spanning Tree
Protocol (STP)
Unidirectional link
detection
Disabled “Configuring UniDirectional Link
Detection” section on page 7-9.
–
Port grouping None
assigned
“Creating EtherChannel Port Groups”
section on page 7-10.
Cluster Manager
Port > Port Grouping
(EC)
Table 4-2 Default Settings and Where To Change Them (continued)
Feature
Default
Setting Concepts and CLI Procedures CMS Option