Chapter 4 General Switch Administration
Default Settings
4-12
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Performance
Configuring a port None Chapter 7, “Configuring the Switch
Ports.”
Cluster Manager
Port > Port
Configuration
and Device > LRE Profile
(for LRE ports only)
Duplex mode
• Auto on all 10/100 ports
• Half duplex on all LRE ports
Cluster Manager
Port > Port
Configuration
“Changing the Port Speed and Duplex
Mode” section on page 7-2.
Speed on 10/100 ports Auto “Changing the Port Speed and Duplex
Mode” section on page 7-2
Cluster Manager
Port > Port
Configuration
Gigabit Ethernet flow
control
• Any on all Gigabit ports
• Disabled on LRE ports in half-duplex mode;
enabled on LRE ports in full-duplex mode
Note This option is configurable only on
the Gigabit ports.
Cluster Manager
Port > Port
Configuration
“Configuring Flow Control on
Gigabit Ethernet Ports” section on
page 7-3.
LRE link speed and
LRE port profiles
LRE-10 “Configuring the LRE Ports” section
on page 7-22.
Cluster Manager
Device > LRE Profile
Configuration
Inline power Auto “Configuring Inline Power on the
Catalyst 3524-PWR Ports” section on
page 7-21
–
Table 4-2 Default Settings and Where To Change Them (continued)
Feature
Default
Setting Concepts and CLI Procedures CMS Option
To Next Page
Loading...
