Chapter 8 Configuring VLANs
Management VLANs
8-6
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Changing the Management VLAN Through a Telnet Connection
Before you start, review the “Management VLANs” section on page 8-4.
Beginning in privileged EXEC mode on the command switch, follow these steps
to configure the management VLAN interface through a Telnet connection:
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
cluster management-vlan
vlanid
Change the management VLAN for the cluster. This ends
your Telnet session. Move the port through which you are
connected to the switch to a port in the new management
VLAN.
Step 3
show running-config Verify the change.
To Next Page
Loading...
Need help?
General