Citrix SD-WAN Platforms
This switches tothe management_ip CLI in the console, and displays the set_management_ip
prompt.
• To configure an IPv6 address:
management_ipv6
This switches tothe management_ipv6 CLI in the console, and displays the set_management_ipv6
prompt.
7. Configure the interface settings for the VM. Enter the following command line at the
set_management_ip prompt:
• For an IPv4 address:
set interface <ip address> <subnet mask> <gateway>
Where:
– <IP address> is the Management IP Address for the SD-WAN VPX-SE Virtual Appliance.
– <subnet mask> is the subnet mask used to define the network in which the CB VPX-VW
Virtual Appliance resides.
– <gateway> is the Gateway IP Address the SD-WAN VPX-SE Virtual Appliance uses to
communicate with external networks.
This stages but does not apply the interface settings.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 176
To Next Page
Loading...