Citrix SD-WAN Platforms
3. Similarly connect the other antenna to the rear SMA coax connector (M) of the appliance.
For more information on configuring the LTE functionality using the GUI and CLI, see Configure LTE
functionality on 210 SE LTE appliance.
Citrix SD-WAN 210 platform support for MiRiC-E1T1 FE/GBE SFP
The following two types of MiRiC SFPs are supported on the 210 appliance for SFP ports 1/5 and 1/6.
1. MiRiC-E1T1 FE SFPs.
2. MiRiC-E1T1 GBE SFPs.
MiRiC-E1T1 FE SFPs must configure with speed as 100 Mbps and duplex as full. MiRiC-E1T1 GBE SFPs
must configure with speed as 1 Gbps and duplex as full.
To configure, go to SD-WAN appliance GUI, navigate to Configuration > Network Adapters > Ethernet
page.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 79
To Next Page
Loading...