CRS-300 1:10 Redundancy Switch MN/CRS300.IOM
Cables and Connections Revision 19
4–43
• HD-15F connector labeled “J1” on the Switch RMI or TMI(s), to
• HD-15F connector labeled “J9 Auxiliary” on the SLM-5650/5650A.
4.6.3 Traffic Data Connections – CRS-300 to Modems
Referring to Figure 4-16:
If HSSI is the traffic data type, do these steps to connect and secure the HSSI Data Cable
CA/WR9189-6 between the Switch and each SLM-5650/5650A:
• HSSI (HD-50F) connector labeled “J2” on the Switch RMI or “J3” on the Switch TMI(s), to
• HSSI (HD-50F) connector labeled “J7 HSSI” on the SLM-5650/5650A.
If EIA-530/-232 is the traffic data type, do these steps to connect and secure the Control/Data
Cable CA/WR0066 (for data purposes) between the Switch and each SLM-5650/5650A:
• DB-25M connector labeled “P2” on the Switch RMI, or “P1” on the Switch TMI(s), to
• DB-25F connector labeled “J6 EIA530” on the SLM-5650/5650A.
Referring to Figure 4-17:
If Balanced G.703 is the traffic data type, do these steps to connect and secure the
CA/WR9038-1 cable between the Switch and each SLM-5650/5650A:
• DB-15M connector labeled “P1” on the Switch RMI or TMI(s), to
• DB-15F connector labeled “J1 Bal Data” on the SLM-5650/5650A.
If Unbalanced G.703 is the traffic data type, do these steps to connect and secure the pair of
BNC PL/0813-8 cables between the Switch and each SLM-5650/5650A:
• BNC connectors labeled “J4 Tx” on the Switch RMI, or “J3 Tx” on the Switch TMI(s), to BNC
connectors labeled “J3 Rx” on the SLM-5650/5650A, and
• BNC connectors labeled “J3 Rx” on the Switch RMI, or “J5 Rx” on the Switch TMI(s), to BNC
connectors labeled “J2 Tx” on the SLM-5650/5650A.
To Next Page
Loading...