CRS-300 1:10 Redundancy Switch MN/CRS300.IOM
Cables and Connections Revision 19
4–45
• DB-25F Jxx “Overhead” connector on the CRS-350 rear panel (where xx specifies the
numbers 1 through 10 Traffic SLM-5650/5650As, and “R11” is reserved for the Redundant
SLM-5650/5650A), to
• DB-25M “P1 Overhead Data” connector on each SLM-5650/5650A.
4.6.6 User ESC Data Connections – CRS-350 to User
You must connect your equipment to the correct corresponding plug-in User Data Interface
(UDI) card on the front panel of the CRS-350. This replaces the direct connection to the Traffic
SLM-5650/5650A’s “Overhead” port.
To Next Page
Loading...