Comtech EF Data CRS-300 - European Union Radio Equipment and Telecommunications Terminal Equipment (R&TTE) Directive (1999;5;EC) and en 301 489-1; European Union Electromagnetic Compatibility (EMC) Directive (2004;108;EC)

To Next Page

To Previous Page

CRS-300 1:10 Redundancy Switch MN/CRS300.IOM

Preface Revision 19

European Union Radio Equipment and Telecommunications Terminal

Equipment (R&TTE) Directive (1999/5/EC) and EN 301 489-1

Independent testing verifies that the unit complies with the European Union R&TTE Directive, its

reference to EN 301 489-1 (Electromagnetic compatibility and Radio spectrum Matters [ERM];

ElectroMagnetic Compatibility [EMC] standard for radio equipment and services, Part 1:

Common technical requirements), and the Declarations of Conformity for the applicable

directives, standards, and practices that follow:

European Union Electromagnetic Compatibility (EMC) Directive

(2004/108/EC)

• Emissions: EN 55022 Class A – Limits and Methods of Measurement of Radio Interference

Characteristics of Information Technology Equipment.

• Immunity: EN 55024 – Information Technology Equipment: Immunity Characteristics, Limits,

and Methods of Measurement.

• EN 61000-3-2 – Harmonic Currents Emission

• EN 61000-3-3 – Voltage Fluctuations and Flicker.

• Federal Communications Commission Federal Code of Regulation FCC Part 15, Subpart B.

CAUTION – TO ENSURE THAT THE UNIT COMPLIES WITH THESE STANDARDS, OBEY

THESE INSTRUCTIONS:

• Use coaxial cable that is of good quality for connections to the L-Band Type ‘N’ Rx (receive)

female connector.

• Use Type 'D' connectors that have back-shells with continuous metallic shielding.

Type ‘D’ cabling must have a continuous outer shield (either foil or braid, or both). The

shield must be bonded to the back-shell.

• Operate the unit with its cover on at all times.