CRS-300 1:10 Redundancy Switch MN/CRS300.IOM
Table of Contents Revision 19
vii
4.10.2 Interface Combinations ..................................................................................................... 4–74
4.10.3 Control Cable Connections – CRS-300 to Modems ........................................................... 4–75
4.10.4 Serial Traffic Data Connections – CRS-300 to Modems .................................................... 4–75
4.10.5 Ethernet Traffic Data Connections – CRS-300 to Modems ............................................... 4–76
4.10.5.1 Wired-thru Connections ............................................................................................... 4–76
4.10.5.2 Wired-around Connections........................................................................................... 4–76
4.10.6 User Data Connections – CRS-300 to User ........................................................................ 4–77
4.11 CDM-600/L Modem Connections ...................................................................................... 4–86
4.11.1 Control and Data Connections – CRS-300 to Modems ..................................................... 4–86
4.11.2 User Data Connections – CRS-300 to User ........................................................................ 4–88
4.11.3 ESC Data Connections – Modems to CRS-350................................................................... 4–88
4.11.4 User ESC Data Connections – CRS-350 to User ................................................................. 4–88
CHAPTER 5. MODEM, RMI/TMI, AND SWITCH CONFIGURATION ............................................ 5–1
5.2 Configure Your Modems .................................................................................................... 5–2
5.2.1 Connect Your Modem Power .................................................................................................. 5–2
5.2.2 Modem Firmware and Hardware Requirements .................................................................... 5–2
5.2.2.1 Update Your Modem Firmware ...................................................................................... 5–3
5.2.3 Configure Your Modem Operation .......................................................................................... 5–3
5.2.4 Configure Your Modems for 1:N Redundancy ........................................................................ 5–3
5.2.4.1 Configure Switch-to-CDM-625/A 1:N Redundancy ........................................................ 5–3
5.2.4.1.1 Configure CDM-625/A 1:N Redundancy for Carrier-in-Carrier® ................................ 5–4
5.2.4.2 Configure Switch-to-CDM-570/A, CDM-570L/AL, CDM-600/L 1:N Redundancy ............ 5–5
5.2.4.3 Configure Switch-to-SLM-5650/5650A 1:N Redundancy ............................................... 5–5
5.2.4.4 Configure Switch-to-CDM-Qx/QxL 1:N Redundancy ...................................................... 5–7
5.2.4.5 Configure Switch-to-CDM-710G/710GL, CDM-710, CDM-700 1:N Redundancy .......... 5–10
5.3 RMI Card Configuration Reference ................................................................................... 5–11
5.4 TMI Card Configuration Reference .................................................................................... 5–12
5.4.1 EIA-530 Interfaces via the CRS-316 TMI ................................................................................ 5–12
5.4.2 EIA-232/-422, V.35 Interfaces via the CRS-320 and CRS-340 TMIs ....................................... 5–15
5.4.3 HSSI Interfaces via the CRS-336 TMI ..................................................................................... 5–17
5.4.4 HSSI Interface via the CRS-370 TMI ....................................................................................... 5–19
5.5 Configure the CRS-300 Switch ........................................................................................... 5–20
5.5.1 Connect the Switch Power .................................................................................................... 5–20
5.5.2 About the Switch Fuses ......................................................................................................... 5–20
5.6 Update the CRS-300 Switch Firmware ............................................................................... 5–21
5.6.1.1 About Firmware Files, Naming, Versions, and Archive Formats .................................. 5–21
5.6.1.2 Switch Firmware Update Procedure ............................................................................. 5–22
5.6.1.2.1 Getting Started: Prepare for the Firmware Download ............................................ 5–22
5.6.1.2.2 Download and Extract the Firmware Update .......................................................... 5–23
5.6.1.2.3 Execute the CCCFLASH Upload Utility Application .................................................. 5–25
5.6.2 Configure the CRS-300 Switch Operation .............................................................................. 5–25
To Next Page
Loading...