Connexity M6504 - Programming a Change of Time; Figure 4: Date and Time Management (Continued)

.
Page 20 15/09/2004 PS8149KENAA01
Ce document est la propriété de EADS et ne doit pas être reproduit ou communiqué sans autorisation.
This document is the property of EADS and may not be copied or circulated without authorisation.
3.1.2 PROGRAMMING A CHANGE OF TIME
MANAGEMENT OF DATE AND TIME
PRESENT TIME AND DATE
- TIME (format hh mm ss) 15 53 14
- DATE (format dd mm yyyy) 30 06 2003
NEXT PROGRAMMED TIME CHANGE YES
- on (date format dd mm) .....
- At (time format hh mm) .....
- IT WILL BE (time format hh mm) .....
------------------------------------------------------
Figure 4: Date and time management (continued)
ON (DATE FORMAT DD MM)
Enter the date of the change: the day (dd) and month (mm), using 2 digits for each value.
AT (TIME FORMAT HH MM)
Enter the time of the change: the hour (hh) and minutes (mm), using 2 digits for each
value.
IT WILL BE (TIME FORMAT HH MM)
Enter the desired time for the change: the hour (hh) and minutes (mm), using 2 digits for
each value.
Note: The date and time can be updated on an attendant console or on a 520 or 640
digital set declared as a maintenance set in its extension characteristics. In
menu 1-7-2 (Miscellaneous Parameters), select YES for date and time
management.
Programming on telephone sets is as follows:
FUNCT. → SERVER → MORE → SYSTEM MANAGEMENT → ACCESS →
DATE and TIME.
The date and time are updated on the sets after any operation (Example: off-
hook/on-hook), after passing 8 p.m. or midnight, by unplugging or plugging in the
sets following an automatic reset.