Connexity M6504 - Card Management (Menu 3-2); Card Type and Status

.
PS8149KENAA01 15/09/2004 Page 21
Ce document est la propriété de EADS et ne doit pas être reproduit ou communiqué sans autorisation.
This document is the property of EADS and may not be copied or circulated without authorisation.
3.2 CARD MANAGEMENT (MENU 3-2)
 For the Call Manager (F5): Menu 3-2 (Card management).
3.2.1 CARD TYPE AND STATUS
Depending on the system installed (M6501L/R IP PBX, XL, XS, XC M6504/M6540 IP
PBX), a screen which displays the various cards installed on the PBX appears: the card
type and status are displayed.
Note: Menu 3-2 (Card management) proposes 4 sub-menus for the X range. To declare
a card in an XL/XS/XC, select menu 3-2-1 (see section 3-2-5) .
TYPE
This field indicates the type of card in the specified location when the PBX is powered on
or on TOTAL RESET.
STATUS
This field indicates the card status:
IN SERVICE: Card being used in the PBX.
DISABLED: Card disabled because of a change being made.
NOT EQUIP.: Card absent from the system or used by an MMC to replace one
card with another of a different type (for example, replacing an
analogue card with a digital card).
FAULTY: Card previously in service and has been removed from the system.
NET ALARM: LSB status for NETWORK cards (in particular PTx/PVI) which
indicates network disconnection (IP, ISDN, etc.).