Connexity M6504 - Figure 35: SVF-BVF Board Access Configuration (F6) (Menu 3-3-2); Svf-Bvf Board Access Configuration (F6) (Menu 3-3-2)

.
PS8149KENAA01 15/09/2004 Page 59
Ce document est la propriété de EADS et ne doit pas être reproduit ou communiqué sans autorisation.
This document is the property of EADS and may not be copied or circulated without authorisation.
3.3.3 SVF-BVF BOARD ACCESS CONFIGURATION (F6) (MENU 3-3-2)
SVF-BVF BOARD ACCESS CONFIGURATION
0-06-00 DIR. IN SERVICE ..........
0-06-01 IVS. DISABLED ..........
SCRIPT GROUP 0
USED BY IN GROUP
SCRIPT 0 74050 .
SCRIPT 1 .
SCRIPT 2 .
SCRIPT 3 .
SCRIPT 4 .
SCRIPT 5 .
SCRIPT 6 .
SCRIPT 7 .
SCRIPT 8 .
SCRIPT 9 .
SCRIPT 11 .
----------------------------------------
Figure 35: SVF-BVF board access configuration (F6) (Menu 3-3-2)
This MMC is used to ENABLE / DISABLE IVS accesses. It is also possible to assign script
groups to the IVS accesses and to divide the scripts into different groups.
0-06-xx: STATUS
Indicates the position and status of the physical access on cards which support spoken
announcements (0-06-00) and voice prompts (0-06-01).
You can proceed as follows:
IN SERVICE DISABLED
IN SERVICE
Physical access being used in the PBX.
DISABLED
Physical access disabled.
SCRIPT GROUPS
A script group is a set of scripts present on a card. Assign a script group to the physical
accesses.
Note: By default, the number of group "0" is assigned to the physical accesses.
SCRIPTX USED BY IN GROUP
Indicates for each script, the logical subscriber(s) used and the group to which it/they
belongs.
Note: To assign or modify the script group numbers, you need to DISABLE the IVS
accesses.