Connexity M6504 - Figure 34: Record Announcements; Record Announcements

.
PS8149KENAA01 15/09/2004 Page 57
Ce document est la propriété de EADS et ne doit pas être reproduit ou communiqué sans autorisation.
This document is the property of EADS and may not be copied or circulated without authorisation.
EXTENSION CABINET
ABSENT DATA + TEL. TELEPHONE
On system start up, this field is configured automatically according to the type of expansion
cabinet.
The composition of the data + telephone expansion cabinet is identical to that of the basic
cabinet.
The telephone expansion cabinet has 14 slots for telephone cards.
3.3.2 RECORD ANNOUNCEMENTS
 F1: Menus 3-3-2 and 5-5-2-8 (BVF: Recording messages)
 F6 (XL/XS/XC): Menus 3-3-1 and 5-5-2-5 (SVF-BVF: Recording messages)
RECORD ANNOUNCEMENTS
PHYSICAL SLOT OF SOURCE …
BOARD PHYSICAL EQUIPMENT …
CATALOGUE NUM/GUIDE …
- LABEL ……..
- DURATION IN SEC. …
RECORDING PARAMETERS
- CATALOGUE-MIXED GUIDE …
- RECORDING LEVEL …
- ATTENUATE MUSIC BY VOICE YES
start recording YES
Figure 34: Record announcements
This menu is used to record customised announcements using a digital or analogue set,
and to replace the pre-configured announcements on the card with new announcements.
Updating messages (also called announcements):
♦ requires the utility MCTOOLS Messages, on a CSS type card (F2)
♦ requires the utility MCTOOLS Messages, on a CC1 type card (F1)
♦ requires the utility M7420 Music Manager on a UTC card (F6).
For messages written in Flash PROM, a list showing the location and length of each
message is displayed. Synchronised messages are broadcast from the beginning. This
menu can therefore be used to listen to the different message on the card without having
to temporarily define a definable tone.
Note: Accessing this menu puts the set out of service: it is therefore not recommended
to access this menu unnecessarily.
PHYSICAL SLOT OF SOURCE
Enter the equipment number of the set from which the announcement will be recorded
(four digits for F1 and five digits for F6).