.
PS8149KENAA01 15/09/2004 Page 29
Ce document est la propriété de EADS et ne doit pas être reproduit ou communiqué sans autorisation.
This document is the property of EADS and may not be copied or circulated without authorisation.
Reminder: The LAS card is used to connect 8 BRIs (type T0 or S0) to ISDN terminals
(8 interfaces, each with 2 B channels (64 kb/s) + 1 D channel (16 kb/s).
For LAS card operation, an IFS link must be declared (+ LAS - CLF wire
plugged in): see "Configuring "IFS" links".
CABINET 2
Cabinet with an FP04E back plane (
TELEPHONE).
CARD TYPE ON TELEPHONE BUS SIDE
CARDS 01 TO 16: TYPE
• • • • • • • • • Use the terminal space bar to select a card type.
16 ANALOG EXT. LAB card with 16 Z interface analogue extensions.
16 DIGITAL EXT. LAI card with 16 I interface digital extensions.
DIGITAL EXT.+TDD LAN.D card with 16 I interface + data digital extensions.
ISDN 8S0 LAS card, 8 S0 equipment interfaces configuration.
8 ANAL. TK.LRA/LRD LRD or LRA card with 8 analogue trunk line equipment interfaces.
4 TIE LINE–A
LIA card with 4 tie-line equipment interfaces and 50 Hz type or E&M
signalling.
4 TIE LINE-B
LIB card with four 2- or 4-wire tie-line equipment interfaces and
voice frequency signalling.
4 TIE LINE-C
LIC card with four 2- or 4-wire tie-line equipment interfaces and
E&M signalling.
8 TIE LINE-E
LIE card with eight 2- or 4-wire tie-line equipment interfaces and
50 Hz, E&M or 2E&2M signalling.
8 AN / 4 DIG / 4 TK
LAR card with 8 Z interface analogue extensions, 4 I interface
digital extensions, and 4 analogue trunk line equipment interfaces.
Note: The telephone expansion cabinet 2 supports LAS 8S cards only.
EQT positions 13 and 14 support LRD and LIX cards only.
Reminder: The LAS card is used to connect 8 T0 BRIs to the ISDN (NUMERIS) or
type S0 to ISDN terminals. 8 circuits each having 2 B channels (64 kbit/s)
+ 1 D channel (16 kbit/s).
To Next Page
Loading...