.
PS8149KENAA01 15/09/2004 Page 51
Ce document est la propriété de EADS et ne doit pas être reproduit ou communiqué sans autorisation.
This document is the property of EADS and may not be copied or circulated without authorisation.
PTX CARD SLOT :
The IP address mask which comprises the number of the sub-network and the number of
the set on the sub-network.
The mask and IP address must respect the following rules:
♦ if the first bit of the IP address is 0 (class A), the mask must be in the form:
255.xxx.xxx.xxx,
♦ if the first two bits of the IP address are 10 (class B), the mask must be in the form:
255.255.xxx.xxx,
♦ if the first three bits of the IP address are 110 (class C), the mask must be in the
form: 255.255.255.xxx.
DEFAULT ROUTER
Router address. Only the IP address is mandatory: non provided data are at 0.
UDP PORT
Port number (5 digits maximum): value between 2050 and 65000 (by default, the port is set
at 40000).
TCP PORTS
- FIRST NUMBER
Port number (5 digits maximum): value between 0 and 65534 (by default, the port is set at
41000).
- LAST NUMBER
Port number (5 digits maximum): value between 0 and 65534 (by default, the port is set at
41999).
The difference between the first and last number of the port must be at least equal to 500.
If this difference is not respected, the second number is automatically updated to restore
this difference.
ETHERNET ADDRESS
ETHERNET or MAC address of card over 6 bytes.
This address is displayed as hexadecimal values separated by dashes. Example: 08-00-
71-03-00-0F
If the card is not in service, the Ethernet address is replaced by: "................"
LINK TYPE
Indicates the type of IP link connected to a PTx card:
♦ ………. (no link present, card “not connected” or “disabled”)
♦ 10 Mb Half Duplex
♦ 10 Mb Full Duplex
♦ 100 Mb Half Duplex
♦ 100 Mb Full Duplex
To Next Page
Loading...