Wireless Controller CLI Reference Guide
129
Set From Zone VLAN using corresponding VLAN
name
Set to Zone security type
Set To Zone VLAN using corresponding VLAN name
Name of the custom service for which a rule is to be
added custom name should already be added into
custom service
Name of the service for which a rule is to be added
Action to be taken by the rule
firew all rule action type
Name of schedule for w hich the rule is applicable
firew all rule address type
Type of the destination user
firew all rule address type
firew all rule snat address type
firew all rule log enable/disable
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
destination_address_start
IP of the Destination user
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
IP of the Destiation user
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Firew all type of service
firew all type of service
OPTION interface for Source NAT settings
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
The port number to use for DNAT, required if port
forwarding is enabled
enable/disable port forwarding based on this firewall
rule configuration settings
Send to Local Server (DNAT IP),Specifies an IP
address and port number of a machine on the Local
Netw ork w hich is hosting the server.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Set it as Dedicated/configured OPION