D-Link DWC-1000

Wireless Controller CLI Reference Guide
22
170
show wlan device_location client macaadr <ltmacaadr>
Display all Triangulation Location Table
parameteres for specifc MAC Address
171
show wlan device_location floor_status
Display On-demand location search floor
status
172
show wlan device_location global_status
Display On-demand location search global
status
173
show wlan device_location floor_status building <ltbuilding>
Building Number
174
show wlan device_location floor_status building_floor
<ltbuilding> <ltfloor>
Floor number to search for the device
175
show wlan device_location floor_status all
Display On-demand location search floor
status
6.2 System
The command show system at the CLI prompt would give the description of all the show
commands in the branch system , which is as follows:
Sl No
Command Name
Purpose
1
show system logging
.
2
show system logging remote
.
3
show system logging remote setup
Display remote logging configuration
4
show system logging facility
.
5
show system logging facility setup <ltfacility>
Display logging facility configuration
6
show system logging ipv4
.
7
show system logging ipv4 setup
Display logging configuration
8
show system logging ipv6
.
9
show system logging ipv6 setup
Display ipv6 logs configuration
10
show system remote_management
.
11
show system remote_management setup
Display remote management over https
configuration
12
show system snmp <ltagentIP>
Display SNMP configuration
13
show system switch_setting
.
14
show system switch_setting power_mode
Display pow er mode configuration
15
show system switch_setting jumbo_frame
Display jumbo frame configuration
16
show system status
Display system status
17
show system time
.
18
show system time setup
Display Timezone and NTP configuration
19
show system traffic_meter
.
20
show system traffic_meter setup
Display traffic meter configuration
21
show system usb
Display USB Configuration
22
show system firmwareVersion
Get's the firmw are Version.
6.3 Net
The command show net at the CLI prompt would give the description of all the show
commands in the branch net , which is as follows:
Sl No
Command Name
Purpose
1
show net ipv6_tunnel status
Display ipv6 tunnels status
2
show net ddns
.
3
show net ddns setup
Show Dynamic DNS Configuration.
4
show net lan dhcp
.