Wireless Controller CLI Reference Guide
81
The local end point address if not the LAN IPv4 address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
12.23 net ipv6_tunnel isatap delete
<ltrow_id>
isatap tunnel configuration mode.
12.24 net routing mode configure
Save NAT configuration changes.
Save NAT configuration changes and exit current mode.
Roll back Basic Security Level configuration changes.
Select NAT or Classical Routing mode.
12.25 net Option Option1 ipv4 configure
Save ipv4 Option configuration changes.
Roll back ipv4 Option configuration changes.
Save ipv4 Option configuration changes and current
mode.
Select among the options: STATIC, DHCP Client,
PPPoE, PPTP, L2TP, Russian PPTP, Russian L2TP,
Japanese Multiple PPPoE
If ISP Type selected is DHCPC, this field gives you
options to configure DHCPC credentials
Enter Yes to get dns dynamically from ISP if you
have not been assigned any static IP address. The
ISP w ill automatically assign an DNS address to the
router using DHCP netw ork protocol. Otherwise
Enter No and give valid static dns addresses
Valid primary DNS Server IP Address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Valid secondary DNS Server IP Address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Select the Mac Address Source
Types of mac address source
MAC address
AA:BB:CC:DD:EE:FF where each
part is in the range 00-FF
If ISP Type selected is STATIC, this field gives you
options to configure STATIC credentials
If your ISP has assigned a fixed (static or permanent)