D-Link DWC-1000

Wireless Controller CLI Reference Guide
27
Chapter 7. Configuration commands
7.1 License Activation commands
The command license at the CLI prompt would give the description of all the
configuration commands in the branch license , which is as follows:
Sl No
Command Name
Purpose
1
license list
List license on the device
2
license activate <ltactivationKey>
activate a license on the device.
7.2 Global configuration commands
The command top at the CLI prompt would give the description of all the configuration
commands in the branch top , which is as follows
Sl No
Command Name
Purpose
1
.top
Return to the default mode
The command reboot at the CLI prompt would give the description of all the
configuration commands in the branch reboot , which is as follows:
Sl No
Command Name
Purpose
1
.reboot
Reboot the system.
The command exit at the CLI prompt would give the description of all the configuration
commands in the branch exit , which is as follows:
Sl No
Command Name
Purpose
1
.exit
Exit this session
7.3 System configuration commands
The command system at the CLI prompt would give the description of all the
configuration commands in the branch system , which is as follows:
Sl No
Command Name
Purpose
1
system logging
.
2
system logging ipv4
System logging configuration.
3
system logging facility
System log Facility configuration.
4
system logging remote
System remoteLogging configuration.
5
system logging ipv6
System ipv6 logs configuration.
6
system logging ipv4 configure
System logging configuration mode.
7
system logging facility configure <ltfacility>
System logging facility configuration
mode.