5.5.2.13 Auto Register
From main window->Setup->Network->Register, the auto register interface is shown as below. See
Figure 5-56.
This function allows the device to auto register to the proxy you specified. In this way, you can use the
client-end to access the DVR and etc via the proxy. Here the proxy has a switch function. In the network
service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the auto
register function, the device can auto register to the proxy server.
Figure 5-56
Please refer to the following sheet for detailed information.
The server IP address or server domain name you want to
register.
The auto registration port value of the server.
The device ID allocated by the server.
5.5.2.14 Alarm Centre
From main window->Setup->Network->Alarm centre, the alarm centre interface is shown as below. See
Figure 5-57.
System can upload alarm signal to the alarm centre when an alarm occurs.
Before you use alarm centre, please set server IP, port and etc. When an alarm occurs, system can send
out data as the protocol defined, so the client-end can get the data.
Figure 5-57
Please refer to the following sheet for detailed information.
Check the box to enable alarm center function.