Click or to adjust channel tour sequence.
Add channel group
Click ,you can see system pops up the following dialogue box. See Figure 5-122. Please select the
channels and then click OK button.
Figure 5-122
Delete channel group
Select a channel group and then click ,you can delete it.
Modify channel group
Select a channel group and then double click, you can see the following interface. See Figure
5-123. You can change the setup and then click OK button.
Figure 5-123
Adjust channel group sequence.
Click or to change channel sequence.
5.5.5.4 RS232
From main menu->Setup->System->RS232, the RS232 interface is shown as in Figure 5-124.
To Next Page
Loading...
