Danfoss iC2 - Page 195

Application Guide | iC2-Micro Frequency Converters
P 6.6.8 Operation Mode
Use this parameter to select the drive operation mode. To reset drive parameter values to default, select [2] Initialization. The
communication related parameters remain unchanged. The frequency converter resets during the next power-up.
Default value: 0 [Normal operation] Parameter type: Selection
Parameter
number:
1422 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 Normal operation
2 Initialization
P6.6.9 Service Code
This parameter is intended for use by service technicians only.
Default value: 0 Parameter type: Range (0–4294967295)
Parameter
number:
1429 Unit: –
Data type: uint32 Access type: Read/Write
P 6.6.12 ECP Copy
Use this parameter to select the ECP copy functions.
Default value: 0 Parameter type: Selection
Parameter
number:
50 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 No copy Do not copy any parameter.
1 All to ECP Copy all parameters in all setups from drive to ECP.
2 All from ECP Copy all parameters in all setups from ECP to drive.
3 Size indep. from ECP Copy only parameters which are independent of motor size, w/o
disturbing motor data already set.
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 195