EasyManuals Logo

Danfoss iC2 User Manual

Danfoss iC2
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #226 background imageLoading...
Page #226 background image
Selection number Selection name Selection description
28 Catch Up Increase reference value by percentage (relative) set in P 5.5.3.13
Freeze Up/Down Step Delta. See Table 66.
29 Slow Down Reduce reference value by percentage (relative) set in P 5.5.3.13
Freeze Up/Down Step Delta. See Table 66.
34 Ramp Bit 0 Enable a selection from the 2 ramps available.
45 Latched Start Reverse The motor starts to run reverse when a pulse is applied for
minimum 4 ms. The motor stops when stop commands are
given.
51 External Interlock This function makes it possible to give an external fault to
the frequency converter. This fault is treated as an internally
generated alarm.
60 Counter A (up) Input for increment counting in the SLC counter A.
61 Counter A (down) Input for decrement counting in the SLC counter A.
62 Reset Counter A Input for reset of counter A.
63 Counter B (up) Input for increment counting in the SLC counter B.
64 Counter B (down) Input for decrement counting in the SLC counter B.
65 Reset Counter B Input for reset of counter B.
101 Sleep A signal applied puts the frequency converter into sleep mode.
P 9.4.1.4 T15 Digital Input
Select the function from the available digital input range.
Default value: 1 [Reset] Parameter type: Selection
Parameter
number:
512 Unit:
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 No Operation No reaction to signals transmitted to the terminal.
1 Reset Resets the frequency converter after a trip/alarm. Not all alarms
can be reset.
2 Coast Inverse Coasting stop, inverted input (NC). The frequency converter
leaves the motor in free mode. Logic 0coasting stop.
3 Coast and Reset Inverse Reset and coasting stop inverted input (NC). Leaves motor in free
mode and resets frequency converter. Logic 0coasting stop.
Logic 1 to Logic 0reset.
226 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss iC2 and is the answer not in the manual?

Danfoss iC2 Specifications

General IconGeneral
BrandDanfoss
ModeliC2
CategoryMedia Converter
LanguageEnglish

Related product manuals