Selection number Selection name Selection description
56 Heat Sink Cleaning Warning, High Activated when the heat sink temperature is not lower than the
calculated value. The calculated Value is equal to the maximum
value of P 2.1.9 Heat Sink Temperature minus the current value of
P 2.1.9 Heat Sink Temperature.
60 Comparator 0 Use result of comparator 0 in logic rule.
61 Comparator 1 Use result of comparator 1 in logic rule.
62 Comparator 2 Use result of comparator 2 in logic rule.
63 Comparator 3 Use result of comparator 3 in logic rule.
64 Comparator 4 Use result of comparator 4 in logic rule.
65 Comparator 5 Use result of comparator 5 in logic rule.
70 Logic rule 0 Use result of logic rule 0 in logic rule.
71 Logic rule 1 Use result of logic rule 1 in logic rule.
72 Logic rule 2 Use result of logic rule 2 in logic rule.
73 Logic rule 3 Use result of logic rule 3 in logic rule.
74 Logic rule 4 Use result of logic rule 4 in logic rule.
75 Logic rule 5 Use result of logic rule 5 in logic rule.
80 SL digital output A See P 8.4.6.2 Action. The output goes high whenever the smart
logic action [38] Set digital out A high is executed. The output
goes low whenever the smart logic action [32] Set digital out A
low is executed.
81 SL digital output B See P 8.4.6.2 Action. The output goes high whenever the smart
logic action [39] Set digital out B high is executed. The output
goes low whenever the smart logic action [33] Set digital out B
low is executed.
160 No Fault The output is high when no alarm is present.
161 Running Reverse The output is high when the frequency converter is running
counterclockwise (the logical product of the status bits Running
AND Reverse).
165 Local Ref. Active The output is high when local reference is activated.
166 Remote Ref. Active The output is high when remote reference is activated.
167 Start Command Active The output is high when there is an active start command, and
no stop command is active.
168 Drive in Local Mode The output is high when the frequency converter is in Local
mode.
169 Drive in Remote Mode The output is high when the frequency converter is in Remote
mode.
193 Sleep Mode The frequency converter/system has entered sleep mode.
194 Lost Load Function A lost-load condition is detected.
242 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Loading...
Need help?
General
